Tryangled Solutions web designing tips tricks

I hate AdSense on blogs. Usually, I ignore it, but I also cast a sharp eye towards the quality of the posts and professionalism of the content when I see AdSense. That’s not to say that contextual advertising can’t work well in some blogs, but it needs to be well integrated into the design and layout to help defer criticism. Don’t get me wrong - it’s unfair to judge a blog by its cover (or, in this case, its ads), but spend a lot of time surfing blogs and you’ll have the same impression - low quality blogs run AdSense and many high quality ones don’t. I always recommend that whether personal or professional, you wait until your blog has achieved a level of success before you start advertising. Ads, whether they’re sponsorships, banners, contextual or other, tend to have a direct, negative impact on the number of readers who subscribe, add to favorites and link - you definitely don’t want that limitation while you’re still trying to get established.

The inside of a computer is a bad place full of electricity and sharp edges. On the electricity side always when working on you computer make sure that it’s still plugged in to the power socket and the power is turned off, this is to ensure that any static From you is discharged through the earth. The inside of most computer cases are unfinished metal and has very sharp edges so be careful.

The first signs of a battery failing are:-

1) your clock starts running slowly
2) when you boot (start) your computer it has a problem finding your hardware (no hard drive, no cd rom)

To change the battery you need the following tools:-

1) a X-point screwdriver
2) an anti-static strap(optional)
3) a new battery (seems logical)

Then unplug all the cables from the back of the computer as you remove them make a note where they came from. (So when you finished you can put them back)

Move the computer somewhere where you can work on it with ease

Remove the cover by locating the screws around the outer edge (back) of the computer
Some computer cases only require you to remove 2 screws on one side then a panel can be removed allowing you access to the computers insides, others you must remove 6 screws and remove the whole case by sliding it to the rear and lifting it off.

Now make sure that you read the safety instructions about static.
Look inside you will see a round silver thing that looks about the size of a 10p piece (quarter). This is the battery itself, carefully lift the retaining clip and slide the battery out. That’s it removed now go to your local computer retailer, electrical retailer (Tandy/Radio shack) taking the old battery with you and get a new battery.

Back to your computer insert the new battery by lifting the clip and sliding the battery in.

Reinstall your case and plug all the cables back (you did remember to label them didn’t you)

Now for the fun part.

You will now need to go into you bios….

Right the bios is the god of your computer.

To access it, when your computer first starts you will see a black screen with white text.

If you look carefully you will see a line that says something like “press del for setup” or some other key (F2 or ESC or tab) this will take you to god’s house where you can make lots of changes to the way your machine works.

It is also the place where you can make your nice computer in to a rather expensive door stop so be careful and don’t go playing with anything.

You will now be presented with a blue screen with a lot of options on it,
The one we want is load optimized/default settings.

Press the F10 key and type y the computer should now reboot.

If every thing went well then your computer will now be up and running.